![]() ![]()
Default baudrate is 115200, later it may be changed to the value you set. COM Port Selected Manually: /dev/ttyUSB0 #DRIVE SNAPSHOT READ ERROR 0X17 SERIAL#usb 1-2.4: FTDI USB Serial Device converter now attached to ttyUSB1 ftdi_sio 1-2.4:1.1: FTDI USB Serial Device converter detected ![]() usb 1-2.4: FTDI USB Serial Device converter now attached to ttyUSB0 ftdi_sio 1-2.4:1.0: FTDI USB Serial Device converter detected usbserial: USB Serial support registered for FTDI USB Serial Device #DRIVE SNAPSHOT READ ERROR 0X17 DRIVER#usbcore: registered new interface driver ftdi_sio usbserial: USB Serial support registered for generic usbcore: registered new interface driver usbserial_generic ![]() usb 1-2.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-2.4: New USB device found, idVendor=0403, idProduct=6010, bcdDevice= 5.00 usb 1-2.4: new full-speed USB device number 11 using xhci_hcd I just went with the latest version available the first time I tried. We could either build the firmware from source or get a binary. Let’s upgrade the firmware as per the Wiki instructions. The board does start with “Welcome to MaixPy” written over a red background. I’ll use the first one for the pupose of this tutorial / getting started guide.īut first let’s connect a USB type-C cable and see what happens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |